Member: Jetfire1

Member: 62oldsf85

Member: JetfireGuy

XTR Prototype
(courtesy of General Motors)

Member: JimNoel

Member: JimNoel
Custom 1962 Jetfire Wagon

Home Blog Blog bumper bolts

bumper bolts

This topic contains 4 replies, has 2 voices, and was last updated by  62cutlassconvert 1 year, 4 months ago.

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
  • #12989


    so upon closer look, the part of the bumper that is vertical that frames the license plate is missing its bolts, and looks like a bracket in the front is also missing. anyone know what sixe these are?



    Here’s some pictures of the bolt for the vertical over-rider. The bolt is a carriage bolt, 1/4″ course with the spacer shown. The bolt slips into the flat sided hole at the bottom of the over-rider, then the spacer goes on, then it contacts the lower valance at the boss and washer and the nut go on the back. Knew I had this somewhere and just found it. Uses a carriage bolt to keep it from turning since you can’t get to the head of the bolt. Should be able to find something that works at you local ACE.






    any idea what the o.d. is on the spacer?



    It’s about 3/4″ long and an OD of about 9/16″.

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.

New Posts in the Forum

Recently Active

Profile picture of kid442
Profile picture of johnsage
Profile picture of captiannapalm
Profile picture of 62cutlassconvert
Profile picture of doctorg
Profile picture of eriftej
Profile picture of joemo
Profile picture of jensenracing77
Profile picture of joe_padavano
Profile picture of JimNoel
Profile picture of macf85
Profile picture of 62oldsf85cutlassmac
Profile picture of bartmo
Profile picture of mikepoe59
Profile picture of oaklyss

Who’s Online

There are no users currently online