Member: Jetfire1












Member: 62oldsf85












Member: JetfireGuy











XTR Prototype
(courtesy of General Motors)












Member: JimNoel











Member: JimNoel
Custom 1962 Jetfire Wagon

Home Blog Blog Clutch and presure plates.

Clutch and presure plates.

Home Page Forums Discussion Topics – Ask the Experts Clutch and presure plates.

This topic contains 5 replies, has 1 voice, and was last updated by  deucephaeton 7 years, 3 months ago.

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #7202

    deucephaeton
    Participant

    Who is a good source of Clutch and Presure Plates for F-85, Cutlass n Jetfire ?

    Luck is at the intersection of planning and opportunity.

    #7203

    kid442
    Participant

    I have a spare 9 1/2″ clutch disc I can spare. You should be able to get the pressure plate rebuilt locally.
    Ken
    kid442w30@yahoo.com

    #7204

    JimNoel
    Participant

    Hi Deuce,
    F-85 and Cutlass use 9 1/2″ clutch & pressure plate. Jetfire uses 10″ clutch & pressure plate.
    D & D can set you up.
    Jim

    #7205

    deucephaeton
    Participant

    Thanks for the D&D reminder.
    Seems their web-site has trouble staying up across all pages. Last time I check the clutch page was down. I’ll try again.
    Someone supplies them or do they build/reman their own?

    Luck is at the intersection of planning and opportunity.

    #7206

    JimNoel
    Participant

    Hi Deuce,
    I have bought new clutch disks and had the three finger style pressure plates rebuilt. You might be able to have that done in your local area? See the notes under Articles, Nuggets from Noel, Tech Articles from Noel, clutch systems. I don’t think D & D rebuilds them, but not sure. However they do it, I know they have supplied in the past. I have one of their 9 1/2″ systems with a three fingered, full spring loaded, pressure plate.
    Jim

    #7207

    deucephaeton
    Participant

    I was able to get on to their site. They have a bad link. Needed to change the link to “.htm” It’s to bad that the entire site is now priced at “Call for quote” I like Dan and he’s been helpful when i purchased a bunch of parts but, this isn’t a good way to run the site. I like to window shop a bit and dream. Sometimes I want to know what I’m getting into before I call. :unsure:

    Luck is at the intersection of planning and opportunity.

Viewing 6 posts - 1 through 6 (of 6 total)

You must be logged in to reply to this topic.

New Posts in the Forum

Recently Active

Profile picture of jensenracing77
Profile picture of JimNoel
Profile picture of kid442
Profile picture of oaklyss
Profile picture of captiannapalm
Profile picture of mikepoe59
Profile picture of rusty1
Profile picture of bartmo
Profile picture of doctorg
Profile picture of joe_padavano
Profile picture of twobolts
Profile picture of johnsage
Profile picture of 62cutlassconvert
Profile picture of macf85
Profile picture of mackemp

Who’s Online

There are no users currently online