Oops, meant to say stock spindle and hubs.
Yep, I would imagine the thickness of the rotor hat would influence the wheel placement further to spindle and hub.

Uses the stock spindle for the 4 lug so no change.

Hello everyone. Still looking for the GLUE-in Windshield Inside Surround Molding for a 62 Jetfire.

I have the mirror center chrome but none of the bottom, side, or top molding.

If you don’t have it all I am interested in what you do have. Mine is all rotten.
Color doesn’t matter.

Thank you Eric for coming up with the rear window interior…[Read more]

What master cylinder did it come with?

I did the 4 lug conversion and am running 15x 6 with a 35/8” backspace. 205 65 15H tire. Wheel Vintique Smoothies. Steel. Lots of alloy wheels available in 5 lug.

Car is dropped with 1” lower springs

Here’s a good alternative for pulling the pan without a lot of work.

The device you see in place above the eng supports the eng with the rod you see headed down out of sight.
Drag link dropped.
The Suspension side mounts were loosened a little, front mount in place, steering was disconnected at the box, the suspension was dropped very little and…[Read more]

Thanks.

Ill ck and see where he is on this.

Pretty sure its glue in. Did you get my PM with contact ino?

I’ll PM you his contact info and you guys can talk direct.

This is what he said he needs: 1962 Jetfire

The molding surrounding the inside of the back window

The molding surrounding the inside of the front window (which I think is only top and bottom but I’m not sure.)

Jetfire emblem for the trunk

Thanks very much

Great, Thanks, ill check with him.
I thinks its a “have one side need the other” kind of thing so maybe he can get a picture.

Be back to you tomorrow probably.

Layne

Checking notify box

Received my new Viton diaphragm valve and have installed. Hope this is the last one!

The also pulled off the end of the valve tube and replaced the stem seal in there. I don’t believe Old Air went that far.

Terrance at Fusick as very helpful.

Thanks for all the comments.

Hi,

The problem is not rebuilding the valve or getting the diaphragm, please read up to the earlier posts for the issue.

Also, I understand there is a stem seal that should be replaced behind the diaphragm. Were you able to get that?

Fusick has now had produced and tested a Viton diaphragm that is resistant to the Evans and other antifreeze like Dexcool with additives corrosive to the commonly used rubber diaphragms.
Doing one for me now. Be glad to have a heater back.

Thanks Joe. The machine shop thinks that’s the way to go too. Think I’ll go that way as well.
My rocker assembly is up to get a new shaft and rocker and checked out.

The rebuilder up in Northern Calif, I’ve heard he’s the guy everyone goes to including D&D, is going to come out with a stronger shaft option. Not available yet but will be after…[Read more]

ckd notify.

I appreciate it.
Yes, it has Fel-Pro now. I am only doing the one side. Yeah I have been looking and have come up with similar cost on an eng set but thought I could buy just one for $15-$20. You can for the Buick eng but not the Olds.
Here’s what I have found since the stripped bolt.
The stripped bolt allowed that journal to lift. In lifting it…[Read more]

Ckd the notify box