So the shop I took my 62 to said the ball joints needed to be replaced but never told me is they were press in or bolt in….Anyone ?

what mods. need to be done to the firewall and tunnel I order to swap out the roto for a 200r4

so upon closer look, the part of the bumper that is vertical that frames the license plate is missing its bolts, and looks like a bracket in the front is also missing. anyone know what sixe these are?

water pump for 62 no a/c

sorry if this has been asked before. am looking for wheel cylinders both front and rear for my 62 cutlass. I am also looking for an idler arm for the same vehicle.

has anyone used this on their 62 with a 215v8? I just installed one, and it ran like crap. reinstalled the points, and runs great. I looked all over for the resistor that needs to be bypassed and could not locate it.
anyone else have the same issue?

my 62 has a 4bb Rochester. when I bought it, it did not have a return spring on it. do these need as return spring? also someone made a poor attempt at the throttle linkage. anyone have a pic or two I could cheat from?

So after a huge panic with the car dying on the way back from a show, turns out it was out of gas. however the guage was reading between E, and 1/4. Any solutions to trouble shhot. I don’t have the special tool required in the manual.